Honda Accord: Cylinder Head -All Models Except PZEV
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Engine Mechanical / Cylinder Head -All Models Except PZEV
- Special Tools
- Cylinder Head
- VTEC Rocker Arm Test
- VTC Actuator Inspection
- Valve Clearance Adjustment
- Crankshaft Pulley Removal and Installation
- Cam Chain Removal
- Cam Chain Installation
- Cam Chain Auto-tensioner Removal and installation
- Cam Chain Case Oil Seal Installatio
- Cam Chain Inspection
- Cf Under Head Cover Mmmmm
- Cylinder Head Cover Installation
- Cf Under Head Removal
- CMP Pulse Plate A Replacement
- CMP Pulse Plate B Replacement
- VTC Actuator, Exhaust Camshaft Sprocket Replacement
- Cylinder Head Inspection for Warpage
- Rocker Arm Assembly Removal
- Rocker Arm and Shaft Disassembly/Reassembly
- Rocker Arm and Shaft inspection
- Camshaft Inspection
- Valve, Spring, and Valve Seal Removal
- Valve Stem-to-Guide Clearance Inspection
- Waive Guide Replacement
- Valve Seat Reconditioning
- Valve, Spring, and Valve Seal Installation
- Rocker Arm Assemblf Installation
- Cylinder Head Installation
- Sealing Bolt Installation
Special Tools
Component Location Index
...
See also:
Cylinder Head
Component Location Index (cont'd)
Engine Compression Inspection
NOTE: After this inspection, you must reset the engine
control module (ECM)/powertrain control module
(PCM), otherwise the ECM ...
VSA Modulator-Control Unit Removal and
Installation
N O T E :
- Do not spill brake fluid on the vehicle; it may damage
the paint. If brake fluid gets on the paint, wash it off
immediately with water.
- Be careful not to damage or deform the brake ...
Reverse Idler Gear Removal and
Installation
Removal
1. Remove the bolt (A) securing the reverse idler gear
shaft holder (B).
2. Install a 5 x 0.8 mm bolt (C) in the reverse idler gear
shaft (D), and pull it to remove the reverse idler gea ...