Honda Accord: Engine Mechanical
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Engine Mechanical
- Engine Assembly
- Cylinder Head -All Models Except PZEV
- Engine Block
- Engine Lubrication
- Intake Manifold and Exhaust System
- Engine Cooling
Troubleshooting
Special Tools Required
Vacuum Pump/Gauge, 0-”30 inHg Snap-on YA4000A or
equivalent commercially available
NOTE:
- Check the vacuum hoses and the lines for damage and
proper connections befor ...
Engine Assembly
...
See also:
In-car Temperature Sensor
Replacement
1. Remove the driver's inner dashboard trim (see page
20-167).
2. Disconnect the connector (A), and remove the in-car
temperature sensor (B) from the air hose (C).
3. Install the sensor in the ...
Secondary Shaft Bearing
Replacement
Special Tools Required
•Driver Handle, 15 x 135L 07749-0010000
•Attachment, 62 x 68 mm 07746-0010500
1. Remove the set plate bolt, then remove the lock
washer (A) and the bearing set pla ...
DTC Troubleshooting
DTC B10A2: Driver's MICU (EEPROM) Error
NOTE: If you are troubleshooting multiple DTCs, be sure
to follow the instructions in B-CAN System Diagnosis
Test Mode A (see page 22-134).
1. Clear the D ...