Exhaust Pipe and Muffler Replacement

NOTE: Use new gaskets and self-locking nuts when reassembling. ...

Cooling System

Component Location Index Radiator Cap Test 1. Wait until the engine is cool, then carefully remove the radiator cap (A). Wet the radiator cap seal with engine coolant, then install it on a com ...

See also:

Mainshaft Assembly Clearance Inspection
1. Support the bearing Inner race with an appropriate sized socket ( A ) , and push down on the mainshaft ( B ) . 2. Measure the clearance between 2nd gear (C) and 3rd gear (D) with a feeler gaug ...

Forced Starting of Display
Special Tools Required SCS Service Connector 07PAZ-0010100 1. Turn the ignition switch to LOCK (0). 2. Connect the SCS service connector (A) to the navigation service connector (B) located behin ...

Reverse Shift Fork Clearance Inspection
1. Measure the clearance between the reverse Idler gear (A) and the reverse shift fork (B) with a feeler gauge (C). If the clearance exceeds the service limit, go to step 2. Standard; 0.20-0.59 mm ...