Honda Accord: Dashboard
- Instrument Visor Removal/Installation
- Driver's Dashboard Lower Cover Removal/Installation
- Driver's Outer Dashboard Trim Removal/Installation
- Driver's Inner Dashboard Trim Removal/Installation
- Center Pocket Removal/Installation
- Dashboard Center Lower Cover Removal/Installation
- Center Display Visor Removal / Installation
- Passenger's Dashboard Trim Removal/Installation
- Glove Box Lock Cylinder Replacement
- Glove Box Removal/Installation
- Glove Box Striker Replacement
- Dashboard Side Vent Removal/Installation
- Dashboard Center Vent Removal / Installation
- Side Defogger Vent Trim Removal/Installation
- Driver's Outer Middle Pad Removal/Installation
- Driver's Inner Middle Pad Removal/Installation
- Passenger's Middle Pad Removal/Installation
- Column Cover Removal/Installation
- Dashboard/Steering Hanger Beam Removal/Installation
- Dashboard/Steering Hanger Beam Disassembly/Reassembly
Accessory Power Socket Trim
Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and
Equipment
Program; call 888-424-6857
NOTE:
- Take care not to scratch the console.
- Use the approp ...
Instrument Visor Removal/Installation
Special Tools Required
KTC Trim Too! Set SOJATP2014*
*Available through the Honda Tool a n d Equipment
Program; call 888-424-6857
NOTE:
- Take care not to scratch the dashboard or the related
pa ...
See also:
General Troubleshooting Information
How to Check for DTCs with the Honda
Diagnostic S f stem (HDS)
When the powertrain control module (PCM) senses an
abnormality in the input or output system, the D
indicator (A) in the gauge contro ...
Driveshaft Removal
Special Tools Required
-Ball Joint Thread Protector, 14 mm 07AAE-SJAA100
-Ball Joint Remover, 28 mm 07MAC-SL0A202
1. Raise and support the vehicle, (see page 1-13)
2. Remove the front wheels.
3 ...
License Plate Light Replacement
4-door
1. Poll the license plate light assembly out, and
disconnect the 2P connector (A) from the license plate
light.
License Plate Light: 5W
2. Separate the lens (B) and housing (C), then rem ...