Wheel Speed Sensor Replacement

Front 1. Turn the ignition switch to LOCK (0). 2. Release the clamp (A), then disconnect the wheel speed sensor connector (B). 3. Remove the bolts and the wheel speed sensor (C). 4. Install ...

Doors

...

See also:

Charging System Indicator
Charging System Indicator If the charging system indicator comes on brightly when the engine is running, the battery is not being charged. Immediately turn off all electrical accessories ...

Low Oil Pressure Indicator Circuit Troubleshooting (Short)
1. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2 on page 11-3). 2. Turn the ignition switch to ON (II). 3. Make sure the HDS communicates with the vehic ...

Fuel Line/Quick-Connect Fitting Installation
NOTE: Before you work on the fuel lines and fittings, read the Fuel Line/Quick-Connect Fitting Precautions (see page 11-313). 1. Check the contact area (A) of the line (B) for dirt or damage, an ...