Honda Accord: Manual Transmission
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Transaxle / Manual Transmission
- Special Tools
- Component Location Index
- Symptom Troubleshooting Index
- Transmission Fluid Inspection and Replacement
- Back-up Light Switch Test
- Transmission Removal
- Transmission Installation
- Transmission Disassembly
- Reverse Shift Fork Clearance Inspection
- Change Lever Clearance Inspection
- Change Lever Assembly Disassembly/Reassembly
- Shift Fork Clearance Inspection
- Shift Fork Disassembly/Reassembly
- Mainshaft Assembly Clearance Inspection
- Mainshaft Disassembly
- Mainshaft Inspection
- Mainshaft Reassembly
- Countershaft Assembly Clearance Inspection
- Countershaft Disassembly
- Countershaft Inspection
- Countershaft Reassembly
- Synchro Sleeve and Hub Inspection and Reassembly
- Synchro Ring and Gear Inspection
- Mainshaft Bearing and Oil Seal Replacement
- Countershaft Bearing Replacement
- Mainshaft Thrust Clearance Adjustment
- Transmission Reassembly
- Gearshift Mechanism Replacement
- Shift Lever Housing Replacement
Clutch Replacement
Special Tools Required
- Clutch Alignment Disc 07JAF-PM7011A
- Ring Gear Holder 07LAB-PV00100 or 07924-PD20003
- Clutch Alignment Tool Set 07PAF-0020000
- Clutch Alignment ...
Special Tools
* : Part of Mainshaft Inspection Tool Set, 07GAJ-PG20102.
* * : Must be used with commercially available 3/8"-16 UNF Slide Hammer. *
...
See also:
Transmission Disassembly
Exploded View-Clutch Housing
1.DIFFERENTIAL ASSEMBLY
2.SHIFT FORK ASSEMBLY
3.6 mm FLANGE BOLT
13 N-m (1.3 kgf-m, 9.4 Ibf-ft)
4.BEARING SET PLATE
5.COUNTERSHAFT ASSEMBLY
6.NEEDLE BEARING
7.OI ...
Replacing a Front Turn Signal/Parking Light Bulb
1. Open the hood.
To change the turn signal bulb on
the passenger’s side, remove the
engine coolant reserve tank by
pulling it out of its stay.
Driver’s side on V6 models
Remove t ...
General Troubleshooting
Information
Lever-Locked Connector
Disconnecting
To disconnect the connector, pull the lever (A) while
pushing the lock tab (B) down, then pull the connector
(C).
Connecting
To connect the connector, push ...