Honda Accord: Special Tools
* : Part of Mainshaft Inspection Tool Set, 07GAJ-PG20102.
* * : Must be used with commercially available 3/8"-16 UNF Slide Hammer. *
See also:
Cylinder Head Installation
1. Install a new coolant separator (A) In the engine block
whenever the engine block is replaced.
2. Clean the cylinder head and the engine block surface.
3. Install the new cylinder head gaske ...
Side Sill Protection Tape Replacement
2-door
1. Slowly remove the old side sill protection tape.
2. Clean the body bonding surface with a shop towel
dampened in isopropyl alcohol. After cleaning, keep
oil, grease, and water from get ...
Defogger Wire Repair
NOTE: To make an effective repair, the broken section
must be no longer than 1.0 in (25 mm).
1. Lightly rub the area around the broken section (A)
with fine steel wool, then clean it with isoprop ...