Honda Accord: Features
The heating and air conditioning system in your vehicle provides a comfortable driving environment in all weather conditions.
The standard audio system has many features. This section describes those features and how to use them.
Your vehicle has an anti-theft audio system that requires a code number to enable it.
The security system helps to discourage vandalism and theft of your vehicle.
- Vents, Heating, and A/C
- Climate Control System
- Audio System
- Playing the XM Radio (EX-L, Canadian EX, and all V6 models without navigation system)
- Playing Discs (Models without navigation system)
- Disc Changer Error Messages (Models without navigation system)
- Playing an iPod (Models without navigation system)
- iPod Error Messages (Models without navigation system)
- Playing a USB Flash Memory Device (Models without navigation system)
- USB Flash Memory Device Error Messages
- Audio System(Models with navigation system)
- Playing the FM/AM Radio (Models with navigation system)
- Playing the XM Radio (Models with navigation system)
- Playing Discs (Models with navigation system)
- Disc Changer Error Messages (Models with navigation system)
- Playing an iPod (Models with navigation system)
- iPod Error Messages (Models with navigation system)
- Playing a USB Flash Memory Device (Models with navigation system)
- USB Flash Memory Device Error Messages (Models with navigation system)
- Protecting Your Discs
- FM/AM Radio Reception
- Remote Audio Controls
- Auxiliary Input Jack
- Radio Theft Protection
- Setting the Clock
- Security System
- Compass
- Cruise Control
- HomeLink Universal Transceiver
- Bluetooth HandsFreeLink
Courtesy Lights
Your vehicle has a courtesy light in
the ignition switch. This light comes
on when you open the driver’s door.
It fades out in about 30 seconds after
the door is closed. ...
Vents, Heating, and A/C
LX and U.S. EX
Fan Control
Turn this dial to increase or decrease
the fan speed and airflow.
Temperature Control
Turning this dial clockwise increases
the temperature of the airflow.
Air Co ...
See also:
Cylinder Head Installation
1. Install a new coolant separator (A) In the engine block
whenever the engine block is replaced.
2. Clean the cylinder head and the engine block surface.
3. Install the new cylinder head gaske ...
Oil Pressure Switch Replacement
1. Disconnect the oil pressure switch connector (A), then
remove the oil pressure switch (B).
2. Remove any old liquid gasket from the switch and
switch mounting hole.
3. Apply a very small am ...
Adding Engine Oil
1. Unscrew and remove the engine oil fill cap.
2. Add oil slowly.
3. Reinstall the engine oil fill cap, and tighten
it securely.
4. Wait for three minutes and recheck the
engine oil dipsti ...