Differential Thrust Clearance Adjustment

Special Tools Required Driver Handle, 40 mm I.D. 07746-0030100 1 Remove trie left driveshaft side oil seal from the transmission housing (see page 13-70). 2. If you removed the 80 mm shim from t ...

Automatic Transmission

...

See also:

Connecting Rod Bolt Inspection
1. Measure the diameter of each connecting rod bolt at point A and point B. 2. Calculate the difference in diameter between point A and point B. Point A-”Point B = Difference in Diameter D ...

Steering Angle Sensor Replacement
SRS components are located In this area. Review the SRS component locations: 4-door (see page 24-21), 2-door (see page 24-23) and the precautions and procedures (see page 24-25). NOTE: Do not da ...

Alternator Control Circuit Troubleshooting
NOTE: Do this troubleshooting if, in step 5 of the alternator and regulator circuit troubleshooting (see page 4-27), the battery voltage is less than 13.5 V. * 1. Connect the Honda Diagnostic Sys ...