Honda Accord: Transmission End Cover
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Transaxle / Transmission End Cover
- End Cover Removal
- Park Lever Stop Inspection and Adjustment
- Idler Gear Shaft Bearing Replacement
- Selector Control Shaft Oil Seal Replacement
- Selector Centre! Sheft Bearing Replacement
- ATF Feed Pipe Replacement
Park Pin Switch Replacement
Type A Shift Lever
NOTE: The AfT gear position indicator panel light
harness and the park pin switch are not available
separately. Replace the A/T gear position indicator panel
light harness and t ...
End Cover Removal
Special Tools Required
Mainshaft Holder 07GAB-PF50101
1. Remove the three bolts (D) securing the ATF cooler inlet line brackets,
the ATF filter bracket bolts (E), the ATF cooler
line banjo bolts ...
See also:
Air Cleaner Removal/Installation
1. Disconnect the MAF sensor/IAT sensor connector (A).
2. Remove the harness clamps (B) and the bolts (C).
3. Loosen the band (D), then remove the air cleaner
housing (E).
4. Install the par ...
Steering Linkage and Gearbox Inspection
...
Gearbox Mount Cushion Replacement
1. Remove the steering gearbox (see page 17-37).
2. Position a 40 mm socket (A) on the flange part of the
gearbox housing with a washer (B), a 10 x 150 mm
flange bolt (C), and a 10 mm nut (D) as ...