Honda Accord: Selector Control Shaft Oil Seal
Replacement - Transmission End Cover - Transaxle - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Selector Control Shaft Oil Seal Replacement

Special Tools Required

-Driver Handle, 15 x 135L 07749-0010000

•Attachment 22 x 24 mm 07746-001A800 1. Remove the oil seal (A) from the end cover (B).

2. Install a new oil seal flush to the end cover using the


2. Install a new oil seal flush to the end cover using the driver handle and the 22 x 24 mm attachment.

Selector Centre! Sheft Bearing


    Idler Gear Shaft Bearing Replacement
    Special Tools Required -Adjustable Bearing Puller, 25—40 mm 07736-A01000B •Driver Handle, 15 x 135L 07749-0010000 -Attachment, 52 x 55 mm 07746-0010400 1. Remove the idler gear shaft be ...

    Selector Centre! Sheft Bearing Replacement
    Special Tools Required •Driver Handle, 15 x 135L 07749-0010000 -Attachment, 22 x 24 mm 07746-001A800 1. Remove the oil seal from the end cover, then remove the bearing. 2. Install a new be ...

    See also:

    Mainshaft Inspection
    1. Inspect the gear and bearing contact areas for wear and damage, then measure the mainshaft at points A, B, C, D, and E. If any part of the mainshaft is less than the service limit, replace it. ...

    Shift Lever Position Indicators
    These indicators on the instrument panel show which position the shift lever is in. Using a paddle shift mode, the gear position indicator shows you the selected gear number. The ‘‘D ...

    Component Location Index Rear Door
    4-door ...