Honda Accord: Ignition Switch
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Body Electrical / Ignition Switch
- Component Location Index
- Circuit Diagram
- Key Interlock System Circuit Troubleshooting
- Key Interlock Solenoid Test
- Park Pin Switch Test
- Ignition Switch Test
- Ignition Switch Replacement
Relays
Power Relay Test
Special Tools Required
Relay Puller 07AAC-000A1A0
Use this chart to identify the type of relay, then do the
test listed for it.
*1:'08-09 models
*2: Carefully remove the relay ...
See also:
A/C Signal Circuit Troubleshooting
NOTE:
• If the blower motor does not run at all speeds, the A/C
compressor will be inoperative. Run the
self-diagnostic function, and check for DTC 12. Before
performing any other troubleshoo ...
Security Hood Switch Test
1. Open the hood.
2. Disconnect the 2P connector from the security hood
switch.
3. Check for continuity between the terminals.
• There should be continuity between terminals No. 1
and ...
Braking System Design
The hydraulic system that operates
the brakes has two separate circuits.
Each circuit works diagonally across
the vehicle (the left-front brake is
connected with the right-rear brake,
etc.). ...
