Ignition Switch

Circuit Diagram

See also:

Middle Crossmember Gusset Replacement
2-door NOTE: Take care not to scratch the body. 1. Remove the rear side trim panel (see page 20-127). 2. Pull back the rear part of the carpet as needed. 3. Remove the bolts (A, B), then rem ...

Damper/Spring Removal and Installation
Removal   1. Raise and support the vehicle (see page 1-13). 2. Remove the front wheel. 3. Remove the wheel speed sensor harness bracket mounting bolt (A). 4. Remove the damper pinch b ...

Clutch Hydraulic System Bleeding
NOTE: - Do not reuse the drained fluid. Always use Honda DOT 3 Brake Fluid from an unopened container. Using a non-Honda brake fluid can cause corrosion and shorten the life of the system. - Ma ...