Changing the Wiper Blade Rubber

1. Lift the driver side wiper arm first, then the passenger side. 2. Press and hold the tab, then slide the blade from the wiper arm. NOTICE Avoid dropping the wiper arm; it may damage the ...

Checking Tires

To safely operate your vehicle, your tires must be of the proper type and size, in good condition with adequate tread, and properly inflated. • Inflation guidelines Properly inflated tires pro ...

See also:

Driveshaft Inspection
1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and the boot ban ...

Ceiling Light
The ceiling light has a three-position switch: ON, Door Activated, and OFF. In the Door Activated (center) position, the light comes on when you: Open either door. Unlock the driver’s do ...

Intermediate Shaft Installation
1. Clean the areas where the Intermediate shaft contacts the differential thoroughly with solvent, and dry then with compressed air. NOTE: Do not wash the rubber parts with solvent. 2. Install ...