ATF Feed Pipe Replacement

1. Remove the snap rings (A), the ATF feed pipes (B), and the feed pipe flanges (C) from the end cover (D). NOTE: Replace the end cover, if the 1st clutch ATF feed pipe (E) replacement is require ...

Housing and Shaft Assembly Removal

Special Tools Required Housing Puller 07HAC-PK40102 1. Remove the ATF feed pipe (A) from the idler gear shaft, and remove the ATF lubrication pipe (B) from the transmission housing. 2. Remove ...

See also:

XM Antenna Replacement
1. Remove the headliner (see page 20-140). 2. Remove the nut (A) from the XM antenna (B). 3. Disconnect the connector (C) and remove the XM antenna. 4. Install the XM antenna in the reverse ...

Front Fender Trim Replacement
2-door NOTE: - Take care not to scratch the front grille cover or the body. - When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage. - The left side is show ...

Oil Pressure Switch Replacement
1. Disconnect the oil pressure switch connector (A), then remove the oil pressure switch (B). 2. Remove any old liquid gasket from the switch and switch mounting hole. 3. Apply a very small am ...