Honda Accord: Keyless/Power Door
Locks/Security System
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Body Electrical / Keyless/Power Door
Locks/Security System
- Component Location Index
- System Description
- Circuit Diagram
- DTC Troubleshooting
- Symptom Troubleshooting Index
- Symptom Troubleshooting
- Control Unit Input Test
- Door Lock Actuator Test
- Door Lock Knob Switch Test
- Door Key Cylinder Switch Test
- Security Hood Switch Test
- Trunk Lid Release Actuator Test
- Transmitter Test
- Tripped Sensor History
MICU input Test
NOTE: Before testing, troubleshoot the multiplex integrated control unit
first, using B-CAN System Diagnosis Test Mode
A (see page 22-134).
Driver's MICU
1. Turn the ignition switch to LOCK (0), ...
Component Location Index
4-door
4-door
2-door
2-door
...
See also:
ENGINE START/STOP Button
• Changing the Power Mode
ENGINE START/STOP Button Operating Range
You can start the engine when the smart entry
remote is inside the vehicle.
The engine may also run if the smart entry r ...
Secondary Shaft Bearing
Replacement
Special Tools Required
•Driver Handle, 15 x 135L 07749-0010000
•Attachment, 62 x 68 mm 07746-0010500
1. Remove the set plate bolt, then remove the lock
washer (A) and the bearing set pla ...
DTC Troubleshooting
DTC P0506: idle Control System RPM Lower
Than Expected
NOTE: Before you troubleshoot record all freeze data
and any on-board snapshot, and review the general
troubleshooting information (see page ...