Honda Accord: Trunk Lid Release Actuator Test
With Keyless Entry
1. Open the trunk lid.
2. Disconnect 3P connector f r om the trunk lid latch switch/trunk release actuator.

3. Check actuator operation by connecting power to terminal No. 3 and ground to terminal No. 2 momentarily. The actuator should work.
4. If the actuator does not work, replace the trunk lid latch switch/release actuator assembly (see page 20-303).
Security Hood Switch Test
1. Open the hood.
2. Disconnect the 2P connector from the security hood
switch.
3. Check for continuity between the terminals.
• There should be continuity between terminals No. 1
and ...
Transmitter Test
NOTE:
• If the doors unlock or lock with the
transmitter, but the
LED on the transmitter does not come on, the LED is
faulty; replace the transmitter.
• If any door is open, you cann ...
See also:
B-CAN System Diagnosis Test Mode
1 and Test Mode 2 (without the
HDS)
Special Tools Required
MFCS (MCIC) Service Connector 07WAZ-00101 OA
Test Mode 1
Check the ECM/PCM for DTCs and troubleshoot
ECM/PCM (see p a g e 11-3) or F-CAN loss o f
communication errors first ...
Shift Solenoid Valve Test,
Replacement, and Shift Solenoid
Wire Harness Replacement
1. Connect the HDS to the DLC (A) located under the
driver's side of the dashboard.
2. Turn the ignition switch to ON (II). Make sure the HDS
communicates with the PCM. If it does not go to the
...
Symptom Troubleshooting
Loiw tire pressure Indicator does not come on,
and no DTCs are stored
NOTE: Check for gauge DTCs with the HDS (see page
22-3). If gauge DTCs are stored, troubleshoot those DTCs
first.
1. Turn t ...