Emblem/Sticker Replacement

2-door NOTE: When removing emblems/sticker, take care not to scratch the body. 1. To remove the front "H" emblem, remove the front bumper (see page 20-255). 2. Clean the body surfaces ...

Front Inner Fender Replacement

NOTE: - Put on gloves to protect your hands. - Take care not to scratch the body. - When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage. 1. Remove the f ...

See also:

Mainshaft Inspection
1. Inspect the gear and bearing contact areas for wear and damage, then measure the mainshaft at points A, B, C, D, and E. If any part of the mainshaft is less than the service limit, replace it. ...

Electrical Compass Unit Input Test
1. Remove the rear shelf (see page 20-128). 2. Loosen the bolts (A), then pull out the electrical compass unit bracket (B). 3. Disconnect the 6P connector (C) and remove the mounting bolt ( D ) ...

Door Glass Adjustment
NOTE: Check the door weatherstrip and the glass run channel for damage or deterioration, and replace them if necessary. 1. Place the vehicle on a firm, level surface when adjusting the door glas ...