Honda Accord: Opening theWindows and Moonroof with the Remote Transmitter - Power Windows - Instruments and Controls - Honda Accord 2008-2012 Owner's ManualHonda Accord: Opening theWindows and Moonroof with the Remote Transmitter

Eighth generation (2008–2012) / Honda Accord 2008-2012 Owner's Manual / Instruments and Controls / Power Windows / Opening theWindows and Moonroof with the Remote Transmitter

You can open both windows and the

You can open both windows and the moonroof (if equipped) from the outside with the remote transmitter.

1. Press the UNLOCK button once to unlock the driver’s door.

2. Press the UNLOCK button a second time, and hold it. The passenger’s door unlocks, and both windows and the moonroof start to open. To stop the windows and moonroof, release the button.

3. To open the windows and moonroof further, press the button again (within 10 seconds of step 1) and hold it. If the windows and the moonroof stop before the desired position, repeat steps 1 and 2.

You cannot close the windows or the moonroof with the remote transmitter.

    Power Windows
    Turn the ignition switch to the ON (II) position to raise or lower either window. To open a window, push the switch down and hold it. Release the switch when you want the window to stop. P ...

    Opening/Closing theWindows and Moonroof with the Key
    You can open and close the windows and the moonroof (if equipped) with the key in the driver’s door lock. To open: 1. Insert the key in the driver’s door lock. 2. Turn the key clockwise ...

    See also:

    Ambient Light Replacement
    With moonroof NOTE: The ambient light is built into the moonroof switch. 1. Remove the front individual map lights (see page 22-258). 2. Disconnect the moonroof switch 12P connector (A) and ...

    Change Lever Assembly Disassembly/Reassembly
    NOTE: Prior to reassembling, clean all the parts in solvent, dry them, and apply grease to contact surfaces as shown. Do not wash the rubber parts with solvent. ...

    Mode Control Motor Replacement
    1. Remove the blower unit (see page 21-65). 2. Disconnect the 7P connector (A) from the mode control motor (B). Remove the self-tapping screws and the mode control motor from the heater unit. ...