Outside Air Temperature Sensor Replacement

1 Disconnect the 2P connector (A) from the outside air temperature sensor (B). 2. Lift the tab (C) to release the lock, then remove the outside air temperature sensor from the front bumper. 3 ...

Component Location Index

4-door 2-door ...

See also:

Ignition Switch Test
NOTE: SRS components are located in the area. Review the SRS component locations 4-door (see page 24-21), 2-door (see page 24-23), and precautions and procedures (see page 24-25) before doing repai ...

Washer Reservoir Replacement
1. Remove the right inner fender (see page 20-290). 2. Disconnect the 2P connector(s) (A) from the washer motor (B) and the washer fluid level switch (Canada models). Washer Reservoir Capacity: ...

Countershaft Inspection
1. Inspect the gear and bearing contact areas for wear and damage, then measure the countershaft at points A, B, and C. If any part of the countershaft is less than the service limit, replace it. ...