Driver's Power Seat Motor Test

1. Remove the d r i v e r ' s seat (see page 20-194). 2. Remove t h e p o w e r seat adjustment switch knobs a nd t h e recline cover f r om t h e seat. • 4-door (see page 20-234) • ...

Component Location Index

...

See also:

Symptom Troubleshooting
VSA activation indicator does not go off, and no DTCs are stored NOTE: If the VSA modulator was replaced prior to the activation indicator turning on, do the VSA sensor neutral position memorizati ...

Ignition Switch Replacement
NOTE: SRS components are located In the area. Review the SRS component locations 4-door (see page 24-21), 2-door (see page 24-23), and precautions and procedures (see page 24-25) before doing repai ...

Stabilizer Link Removal/Installation
1. Raise and support the vehicle (see page 1 -13). 2. Remove the rear wheel. 3. Remove the flange nut (A) and the self-locking nut (B) while holding the respective joint pin (C) with a hex wre ...