Honda Accord: Switch Test/Replacement - Power Lumbar Support - Body Electrical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Switch Test/Replacement

1. Separate the lumbar support switch cover (A) from the switch (B).

2. Disconnect the 5P connector (C) from the switch.


2. Disconnect the 5P connector (C) from the switch.

3. Check for continuity between the terminals in each switch position according to the table.

4. If the continuity is not as specified, replace the switch.


4. If the continuity is not as specified, replace the switch.

    Circuit Diagram
    ...

    Motor Test
    1. Remove the front seat back panel, and seat-back cover/pad. • 4-door (see page 20-221) • 2-door (see page 20-213) 2. Disconnect the 2P connector (A) from the lumbar support motor (B ...

    See also:

    Cf Under Head Cover Mmmmm
    1. Remove the strut brace (if equipped) (see page 20-306). 2. Remove the engine cover. 3. Remove the four ignition coils (see page 4-20). 4. Remove the dipstick (A), and the power steering ( ...

    Idler Gear Shaft Bearing Replacement
    Special Tools Required -Adjustable Bearing Puller, 25—40 mm 07736-A01000B •Driver Handle, 15 x 135L 07749-0010000 -Attachment, 52 x 55 mm 07746-0010400 1. Remove the idler gear shaft be ...

    Protecting Discs
    When a disc is not being played, store it in its case to protect it from dust and other contamination. To prevent warpage, keep discs out of direct sunlight and extreme heat. To clean a disc, ...