Honda Accord: Front and Rear Suspension
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Suspension / Front and Rear Suspension
- Special Tools
- Component Location Index
- Wheel Alignment
- Wheel Bearing End Play Inspection
- Wheel Runout Inspection
- Wheel Bolt Replacement
- Ball Joint Removal
- Ball Joint Boot Inspection / Replacemen
Suspension
...
Special Tools
...
See also:
Symptom Troubleshooting
No picture Is displayed
Diagnostic Test: Self-Diagnosis ModВ©
NOTE:
• Check the vehicle battery condition first (see page
• 22-90).
• Check button has been pressed,
and turn ...
A/T Clutch Pressure Control Solenoid
Valve A Test
1. Connect the HDS to the DLC (A) located under the
driver's side of the dashboard.
2. Turn the ignition switch to ON (II). Make sure the HDS
communicates with the PCM. If it does not, go to the
...
Hood Seal and Hood Molding
Replacement
NOTE: Take care not to scratch the hood.
1. Detach the clips (A) with a clip remover, then remove
the hood seal (B). On Canada models: Detach the clips
(C), then remove the hood molding (D).
2-d ...