Honda Accord: Starting System
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Engine Electrical / Starting System
- Component Location Index
- Symptom Troubleshooting Index
- Circuit Diagram
- Starter System Circuit Troubleshooting
- Clutch Interlock Switch T e s t
- Clutch Interlock Switch Replacement
- Starter Performance Test
- Starter Removal and Installation
- Starter Overhaul
Special Tools
...
See also:
Secondary Shaft 2nd Gear Axial
Clearance Inspection
1. Install the thrust needle bearing (A), the needle
bearing (B), 2nd gear (C), the thrust needle bearing
(D), the 37 x 58 mm thrust washer (E), and the 2nd
clutch (F) on the secondary shaft (G), t ...
Steering Wheel Removal
SRS components are located in this area. Review the
SRS component locations: 4-door {see page 24-21),
2-door (see page 24-23) and the precautions and
procedures (see page 24-25) before doing repair ...
XM Receiver Removal/Installation
1. Open the trunk lid, and remove the right trunk side
trim panel {see page 20-132).
2. Disconnect the connectors (A) from the XM receiver
(B).
4-Door
3. Remove the mounting bolt (C) and lo ...