Honda Accord: Rocker Arm Oil Pressure Switch
Removal/Installation
All models except PZEV
1. Disconnect the rocker arm oil pressure switch connector (A).
2. Remove the rocker arm oil pressure switch (B).
3. Install the parts in the reverse order of removal with a new O-ring (C).
Rocker Arm Oil Control Valve
Removal/Installation
All models except PZEV
1. Remove the strut brace (see page 20-306).
2. Disconnect the rocker arm oil control solenoid
connector (A) and the rocker arm oil pressure switch
connector (B).
3. Re ...
Rocker Arm Oil Pressure Switch A
Removal/Installation
PZEV model
1. Remove the rocker arm oil control valve (see page
11-275).
2. Remove rocker arm oil pressure switch A.
3. Install the parts in the reverse order of removal with a
new O-ring (B) ...
See also:
Door Position Adjustment
NOTE: Check for a flush fit with the body, then check for
equal gaps between the front, rear, and bottom door
edges and the body. Check that the door and body edges
are parallel.
1. Place the ve ...
Recirculation Control Motor Test
NOTE: Before testing the motor, check for HVAC DTCs
(see page 21-101).
1. Disconnect the 7P connector from the recirculation
control motor.
Incorrectly applying power and ground to the
recirc ...
Reverse Idler Gear Removal and
Installation
Removal
1. Remove the bolt (A) securing the reverse idler gear
shaft holder (B).
2. Install a 5 x 0.8 mm bolt (C) in the reverse idler gear
shaft (D), and pull it to remove the reverse idler gea ...