Honda Accord: Rocker Arm Oil Pressure Switch A
Removal/Installation - VTEC/VTC - Fuel and Emissions - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Rocker Arm Oil Pressure Switch A Removal/Installation

PZEV model

1. Remove the rocker arm oil control valve (see page 11-275).

2. Remove rocker arm oil pressure switch A.

3. Install the parts in the reverse order of removal with a


3. Install the parts in the reverse order of removal with a new O-ring (B).

    Rocker Arm Oil Pressure Switch Removal/Installation
    All models except PZEV 1. Disconnect the rocker arm oil pressure switch connector (A). 2. Remove the rocker arm oil pressure switch (B). 3. Install the parts in the reverse order of removal wi ...

    Rocker Arm Oil Pressure Switch B Removal/Installation
    PZEV model 1. Remove the rocker arm oil control valve (see page 11-275). 2. Remove rocker arm oil pressure switch B. 3. Install the parts in the reverse order of removal with a new O-ring (A) ...

    See also:

    Bearing Removal
    Special Tools Required •Attachment, 78x80 mm 07NAD-PX40100 -Driver Handle, 15 x 135L 07749-0010000 -Bearing Driver Attachment, 42 x 47 07746-0010300 1. Remove the idler gear shaft (see page 1 ...

    Seat Heaters
    EX-L and all V6 models Both front seats are equipped with seat heaters. Because of the sensors for the side airbag cutoff system, there is no heater in the passenger’s seat-back. The igni ...

    Oil Pressure Switch Replacement
    1. Disconnect the oil pressure switch connector (A), then remove the oil pressure switch (B). 2. Remove any old liquid gasket from the switch and switch mounting hole. 3. Apply a very small am ...