Honda Accord: Rocker Arm Oil Pressure Switch B
Removal/Installation - VTEC/VTC - Fuel and Emissions - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Rocker Arm Oil Pressure Switch B Removal/Installation

PZEV model

1. Remove the rocker arm oil control valve (see page 11-275).

2. Remove rocker arm oil pressure switch B.

3. Install the parts in the reverse order of removal with a


3. Install the parts in the reverse order of removal with a new O-ring (A),

    Rocker Arm Oil Pressure Switch A Removal/Installation
    PZEV model 1. Remove the rocker arm oil control valve (see page 11-275). 2. Remove rocker arm oil pressure switch A. 3. Install the parts in the reverse order of removal with a new O-ring (B) ...

    Idle Control System
    ...

    See also:

    Balancer Shaft Inspection
    1. Seat the balancer shaft by pushing it away from the oil pump sprocket end of the oil pump. 2. Zero the dial indicator against the end of the balancer shaft, then push the balancer shaft back a ...

    Glove Box Removal/Installation
    Special Tools Required KTC Trim Tool Set SOJATP2014* *Available through the Honda Tool and Equipment Program; call 888-424-6857 SRS components are located in this area. Review the SRS component l ...

    Symptom Troubleshooting
    Rapid brake pad wear, vehicle vibration (after a long drive), or high, hard brake pedal NOTE: Make sure that the caliper pins are installed correctly. Upper caliper pin B and lower caliper pin A ar ...