Switch Test/Replacement

1. Remove the center console panel (see page 20-157). 2. Disconnect the 6P (or 7P*) connector from the seat heater switch, then remove the switch. *: Front passenger's seat heater switch 3. ...

Component Location Index

With navigation system   ...

See also:

Countershaft Disassembly, Inspection, and Reassembly
1. Inspect the needle bearings for galling and rough movement. 2. Inspect the splines for excessive wear and damage. 3. Check the shaft bearing surface for scoring and excessive wear. 4. Lubr ...

Low Oil Pressure Indicator Circuit Troubleshooting (Short)
1. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2 on page 11-3). 2. Turn the ignition switch to ON (II). 3. Make sure the HDS communicates with the vehic ...

Ignition Switch Test
NOTE: SRS components are located in the area. Review the SRS component locations 4-door (see page 24-21), 2-door (see page 24-23), and precautions and procedures (see page 24-25) before doing repai ...