Honda Accord: Switch Test/Replacement - Seat Heaters - Body Electrical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Switch Test/Replacement

1. Remove the center console panel (see page 20-157).

2. Disconnect the 6P (or 7P*) connector from the seat heater switch, then remove the switch.

*: Front passenger's seat heater switch

3. Check for continuity between the terminals in each


3. Check for continuity between the terminals in each switch position according to the table.

NOTE: Make sure the correct test lead (+ or —) is placed on the terminal.

[ ] : Front passenger's seat heater switch


[ ] : Front passenger's seat heater switch

4. If the continuity is not as specified, replace the switch.

    Seat Heater Test
    Driver's Seat 1. Remove the driver's seat (see page 20-194). 2. Remove the seat back panel. • 4-door (see page 20-221) • 2-door (see page 20-213) 3. Disconnect the connector A (4P) ...

    Rear Window Defogger
    ...

    See also:

    Valve Clearance Adjustment
    Special Tools Required . Locknut Wrench 07MAA-PR70120 . Adjuster 07MAA-PR70110 NOTE: Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) and monitor the engine coolant temp ...

    Audio System
    Audio System An audio system is standard on all models. Read the appropriate pages (as shown below) to use your vehicle’s audio system. ...

    DTC Troubleshooting
    DTC P0506: idle Control System RPM Lower Than Expected NOTE: Before you troubleshoot record all freeze data and any on-board snapshot, and review the general troubleshooting information (see page ...