Honda Accord: Power Mirror Switch
Test/Replacement
1. Remove the power window master switch.
• 4-door (see page 22-305) • 2-door (see page 22-306) 2. Disconnect the 13P connector from the power mirror switch (A).
3. Check for continuity between the terminals in each switch position according to the table.
4. If the continuity is not as specified, remove the screws and replace the power mirror switch.
Front Passenger's Power Window
Switch input Test
1. Turn the ignition switch to LOCK (0), open and close the driver's door,
then remove the front passenger's
(passenger's) power window switch.
- • 4-door (see page 22-306)
• 2-door ( ...
Power Mirror Actuator Test
1. Remove the mirror mount cover (see page 20-62).
2. Disconnect the 8P connector (A) from the power
mirror actuator (B).
3. Check the actuator operation by connecting battery
power and ground ...
See also:
DTC Troubleshooting
DTC B10CF: Left Daytime Running Lights
Circuit Malfunction
NOTE:
• Make sure the No. 15 (7.5 A) fuse in the driver's
under-dash fuse/relay box is OK.
• If you are troubleshooting mult ...
Cylinder Head Inspection for
Warpage
1. Remove the cylinder head (see page 6-76).
2. Inspect the camshaft (see page 6-84).
3. Check the cylinder head for warpage. Measure along
the edges, and three ways across the center.
- If ...
Ball Joint Boot Inspection / Replacemen
Special Tools Required
- Clip Guide, 45 mm 070AG-SJA0300
-Clip Guide, 41 mm 07974-SA50700
1. Check the ball joint boot for weakness, damage,
cracks, and grease leaks.
NOTE:
- If the ball joint ...