Honda Accord: MAF Sensor/IAT Sensor Replacement - PGM-FI System - Fuel and Emissions - Honda Accord MK8 2008-2012 Service ManualHonda Accord: MAF Sensor/IAT Sensor Replacement

1. Disconnect the MAF sensor/IAT sensor connector (A).

2. Remove the screws (B).


2. Remove the screws (B).

3. Remove the MAF sensor/IAT sensor (C).

4. Install the parts in the reverse order of removal with a new O-ring (D).

    MAP Sensor Replacement
    1. Disconnect the MAP sensor connector (A). 2. Remove the MAP sensor (B). 3. Install the parts in the reverse order of removal with a new O-ring (C). ...

    ECT Sensor 1 Replacement
    1. Drain the engine coolant (see page 10-6). 2. Disconnect the ECT sensor 1 connector (A). 3. Remove ECT sensor 1 (B). 4. Install the parts in the reverse order of removal with a new O-ring ...

    See also:

    Stabilizer Link Removal/Installation
    1. Raise and support the vehicle (see page 1 -13). 2. Remove the rear wheel. 3. Remove the flange nut (A) and the self-locking nut (B) while holding the respective joint pin (C) with a hex wre ...

    Under-floorTWC Removal/Installation
    1. Raise the vehicle on a lift. 2. Remove the exhaust pipe hangers (A). 3. Remove the under-floor TWC (B). 4. Install the parts in the reverse order of removal with new gaskets (C) and new s ...

    If the Engine Overheats
    The pointer of your vehicle’s temperature gauge should stay in the midrange under most conditions. If it climbs to the red mark, you should determine the reason (hot day, driving up a steep ...