Honda Accord: ECT Sensor 1 Replacement - PGM-FI System - Fuel and Emissions - Honda Accord MK8 2008-2012 Service ManualHonda Accord: ECT Sensor 1 Replacement

1. Drain the engine coolant (see page 10-6).

2. Disconnect the ECT sensor 1 connector (A).

3. Remove ECT sensor 1 (B).


3. Remove ECT sensor 1 (B).

4. Install the parts in the reverse order of removal with a new O-ring (C), then refill the radiator with engine coolant (see page 10-6).

    MAF Sensor/IAT Sensor Replacement
    1. Disconnect the MAF sensor/IAT sensor connector (A). 2. Remove the screws (B). 3. Remove the MAF sensor/IAT sensor (C). 4. Install the parts in the reverse order of removal with a new O-ri ...

    ECT Sensor 2 Replacement
    1. Remove the front splash shield, (see page 20-291) 2. Drain the engine coolant (see page 10-6). 3. Disconnect the ECT sensor 2 connector (A), then remove ECT sensor 2 (B). 4. Install ECT sen ...

    See also:

    Audio, Navigation, and Telematics
    Special Tools ...

    Front Seat Removal/Installation
    Special Tools Required KTC Trim Tool Set SOJATP2014* *Available through the Honda Tool and Equipment Program; call 888-424-6857 SRS components are located in this area. Review the SRS component ...

    Special Tools
    Component Location Index ...