Honda Accord: Folder Scan
This feature, when activated, samples the first file in each folder for 10 seconds. To scan a folder, press the SCAN side of the SCAN/ A. SEL bar repeatedly. You will see SCAN next to FOLDER and the folder number blinking.
To listen to the rest of the folder, press and hold the SCAN side of the bar until you hear a beep. If you do nothing, the system advances to the next folder, plays 10 seconds of it, and continues with the remaining folders in the same way. When the system has finished sampling the first file in all folders, folder scan is canceled, and the last file played continues to play.
Changing the Folders
While playing an MP3/WMA disc,
you can select a folder within the
disc by pressing either side of the
category bar. Each time you press
either side of the bar, the folder title
and its first ...
Folder Repeat
This feature, when activated, replays
all files in the selected folder. To
activate folder repeat mode, select
FOLDER REPEAT by using the
interface knob, and press ENTER on
the interface sel ...
See also:
In-car Temperature Sensor Test
NOTE: Before testing the sensor, check for HVAC DTCs
(see page 21-101).
1. Remove the in-car temperature sensor (see page
21-184).
2. Test the in-car temperature sensor while holding it in
fr ...
Door Key Cylinder Switch Test
1. Remove the driver's door panel (see page 20-17).
2. Disconnect the 10P connector (A) from the door lock
actuator (key cylinder switch) (B).
3. Check for continuity between the terminals.
...
A/C Condenser Fan High Speed Circuit
Troubleshooting
ECM/PCM CONNECTOR A (49P)
Terminal side of female terminals
Is there battery voltage?
YES-Go to step 6.
NO-Repair an open in the wire between the
under-hood fuse/relay box and the ECM/PCM. If ...