Honda Accord: Folder Repeat
This feature, when activated, replays all files in the selected folder. To activate folder repeat mode, select FOLDER REPEAT by using the interface knob, and press ENTER on the interface selector. You will see REPEAT next to FOLDER on the screen. To turn this feature off, highlight FOLDER REPEAT (if not already highlighted), and press ENTER on the interface selector again.
To select any type of the repeat modes, use the interface dial. For more information.
Folder Scan
This feature, when activated,
samples the first file in each folder
for 10 seconds. To scan a folder,
press the SCAN side of the SCAN/
A. SEL bar repeatedly. You will see
SCAN next to FOLDER ...
Folder Random
This feature, when activated, plays
all files in the current folder in
random order. To activate folder
random play, select FOLDER
RANDOM by using the interface
knob, and press ENTER on the ...
See also:
Low Oil Pressure Indicator Circuit Troubleshooting (Short)
1. Connect the Honda Diagnostic System (HDS) to the
data link connector (DLC) (see step 2 on page 11-3).
2. Turn the ignition switch to ON (II).
3. Make sure the HDS communicates with the vehic ...
Driveshaft Disassembly
Special'Tools Required
•Threaded Adapter, 26 x 1.5 mm
07XAC-001030A
-Slide Hammer 5/8M-18 UNF, commercially available
-Bearing Puller, commercially available
-Boot Band Pliers, commercially ...
Outside Air Temperature Sensor Test
1 Remove the outside air temperature sensor (see page
22-353).
2. Dip the sensor in ice water, and measure the
resistance. Then pour warm water on the sensor, and
check for a change in resistanc ...