Honda Accord: Turn Signal/Hazard Warning Lights
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Body Electrical / Turn Signal/Hazard Warning Lights
- Component Location index
- Circuit Diagram
- DTC Troubleshooting
- MICU Input Test
- Hazard Warning Switch Test/Replacement
Brake Pedal Position Switch Test
1. Disconnect the 4P connector (A) from the brake pedal
position switch (B).
2. Check for continuity between terminals No. 1 and No.
2.
• There should be continuity when the brake pedal ...
See also:
Mainshaft 5th Gear Axial Clearance
Inspection
1. Remove the mainshaft transmission housing bearing
(seepage 14-270).
2. Install the thrust needle bearing ( A ) , 5th gear ( B ) , the
needle bearing (C), the thrust needle bearing (D), the
41 ...
Mainshaft Inspection
1. Inspect the gear and bearing contact areas for wear
and damage, then measure the mainshaft at points A,
B, C, D, and E. If any part of the mainshaft is less than
the service limit, replace it.
...
Rear License Plate Light Bulbs
When replacing, use the following bulbs.
1. Remove the license plate light assembly by
pushing the left edge of the lens toward the
right and pulling the assembly out.
2. Remove the lens b ...
