Component Location index

...

DTC Troubleshooting

DTC B1280: Turn Signal Switch Circuit Malfunction NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see page 22-134). 1. ...

See also:

System Diagnostic Mode
Start-up procedure and Diagnostic IVieny There are two ways t o enter the diagnostic mode: Method 1 : Start the vehicle. When the globe screen appears, connect the SCS service connector (see page ...

Battery Terminal Disconnection and Reconnection
Disconnection NOTE: Some systems store data in memory that is lost when the battery is disconnected. Do the following procedures before disconnecting the battery, 1. Make sure you have the anti-th ...

Trunk Light Test/Replacement
1. Open the trunk lid. 2. Carefully pry out the trunk light (A). Trunk Light: 5 W 3. Disconnect the 2P connector (B) from the trunk light. 4. Check for continuity between terminals No. 1 ( + ...