Turn Signal/Hazard Warning Lights

Circuit Diagram

See also:

Cylinder Head Inspection for Warpage
1. Remove the cylinder head (see page 6-76). 2. Inspect the camshaft (see page 6-84). 3. Check the cylinder head for warpage. Measure along the edges, and three ways across the center. - If ...

Rewriting the ODO Data and Transferring the Maintenance Minder Data to a New Gauge Control Module
NOTE: • Obtain a new gauge control module before starting the rewriting process. Only new gauges can be rewritten. • Rewriting is not possible on a gauge control module that will not ...

Alternator Removal and Installation
Removal 1. Do the battery terminal disconnection procedure (see page 22-91). 2. Remove the drive belt (see page 4-30). 3. Remove the two bolts securing the alternator. 4. Disconnect the alt ...