Rear Bumper Finisher Cover Replacement

2-door NOTE: - Put on gloves to prevent damage. - Take care not to scratch the rear bumper or the body. - When prying with a flat-tip screwdriver, wrap it with protective tape to prevent dama ...

Hood Adjustment

1. Remove these Items: - Front grille cover: - 2-door (see page 20-274) - 4-door (see page 20-274) - Cowl covers (see page 20-278) - Hood latch cover, 4-door (see step 2 on page 20-302) 2. Sligh ...

See also:

Front Door Panel Removal/Installation
Special Tools Required -KTC Trim Tool Set SOJATP2014* -Trim Pad Remover Snap-on A 177A, commercially available *Available through the Honda Tool and Equipment Program; call 888-424-6857 2-do ...

Front Seat Slide Motor Replacement
SRS components are located in this area. Review the SRS component locations, 2-door (see page 24-23), 4-door (see page 24-21) and the precautions and procedures (see page 24-25) before doing repair ...

EVAP Canister Replacement
1. Raise the vehicle on a lift. 2. Remove the wheel sensor harness clamps (A) 3. Support the rear subframe with a transmission jack and a wooden block as shown. 4. Remove the rear subframe m ...