Honda Accord: Exterior Trim
- Front Grille Cover Replacement
- Front Grille Replacement
- Front Fender Trim Replacement
- Cowl Cover Replacement
- Roof Molding Replacement
- Side Sill Protection Tape Replacement
- Trunk Lower Trim Replacement
- Emblem/Sticker Replacement
Fuel Cap Adapter Replacement
NOTE:
- Put on gloves to protect your hands.
- Take care not to scratch the body.
1. Remove the fuel pipe protector (see page 20-294).
2. Remove the fuel cap (A) by turning it
counterclockw ...
Front Grille Cover Replacement
2-door
NOTE:
- Take care not to scratch the front grille or the body.
- When prying with a flat-tip screwdriver, wrap it with
protective tape to prevent damage.
1. Remove the front grille cov ...
See also:
Accelerator Pedal Module
Removal/Installation
1. Disconnect the APP sensor connector (A).
2. Remove the accelerator pedal module (B).
NOTE: The APP sensor is not available separately. Do
not disassemble the accelerator pedal module.
3. ...
Taillight and Back-Up Light Bulbs
When replacing, use the following bulbs.
1. Remove the holding clips using a flat-tip
screwdriver, then pull the lining back.
2. Turn the socket to the left and remove it.
3. Remove the ol ...
ECT Sensor 2 Replacement
1. Remove the front splash shield, (see page 20-291)
2. Drain the engine coolant (see page 10-6).
3. Disconnect the ECT sensor 2 connector (A), then
remove ECT sensor 2 (B).
4. Install ECT sen ...