Reverse Lockout

6-speed manual transmission only The manual transmission has a lockout so you cannot accidentally shift from any forward gear to reverse while the vehicle is moving at a certain speed. If you ...

Shift Lever Position Indicators

These indicators on the instrument panel show which position the shift lever is in. Using a paddle shift mode, the gear position indicator shows you the selected gear number. The ‘‘D ...

See also:

APP Sensor Signal I n s p e c t i o n
NOTE: - This procedure checks the APP sensor in its fully closed position. In any other position, the APP sensor stores DTCs which are covered in other troubleshooting procedures. - Check for P ...

Secondary Shaft Disassembly, Inspection, and Reassembly
1. Inspect the thrust needle bearings a n d the needle bearings for g a l l i n g and rough movement 2. Inspect the splines for excessive wear and damage. 3. Check the shaft bearing surface fo ...

Wheel Runout Inspection
1. Raise and support the vehicle (see page 1 -13). 2. Check for a bent or deformed wheel. 3. Set up the dial gauge as shown, and measure the axial runout by turning the wheel. Front and rear w ...