Honda Accord: Under-dash Fuse/Relay Box
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Body Electrical / Under-dash Fuse/Relay Box
- Driver's Under-dash Fuse/Relay Box (MICU) Removal and Installation
- Passenger's Under-dash Fuse/Relay Box (MICU) Removal and Installation
Under-hood Fuse/Relay Box
Removal and Installation
Special Tools Required
Relay Puller 07AAC-000A1A0
NOTE; The under-hood fuse/relay box is a part of the left
engine compartment wire harness, and it cannot be
replaced by ...
Driver's Under-dash Fuse/Relay Box
(MICU) Removal and Installation
Special Tools Required
Relay Puller 07AAC-000A1A0
USA models
NOTE; SRS components are located in this area. Review
the SRS component locations 4-door (see page 24-21),
2-door (see page 24-23), an ...
See also:
Adjusting the Sound
1. Press the SETTINGS button.
2. Rotate to select Audio
Settings, then
press .
3. Rotate to select Sound,
then press .
Rotate to scroll through the
following
choices:
The SVC ...
Intermediate Shaft Installation
1. Clean the areas where the Intermediate shaft contacts
the differential thoroughly with solvent, and dry then
with compressed air.
NOTE: Do not wash the rubber parts with solvent.
2. Install ...
Stabilizer Bar Replacement
1. Raise and support the vehicle (see page 1-13).
2. Remove the rear wheels.
3. Disconnect both stabilizer links from the stabilizer bar
(see page 18-47).
4. Remove the flange bolts (A) and ...