Honda Accord: Track Repeat
To replay the current track continuously, select TRACK REPEAT, and press ENTER on the interface selector. As a reminder, you will see REPEAT next to TRACK on the screen. To turn this feature off, highlight TRACK REPEAT (if not already highlighted), and press ENTER on the interface selector again.
Disc Scan
When you press the SCAN side of
the SCAN/A. SEL bar repeatedly
until you see D-SCAN in the center
display, or push the interface
selector to the right, the first track of
the current disc pl ...
Disc Repeat
To replay the current disc
continuously, select DISC REPEAT,
and press ENTER on the interface
selector. As a reminder, you will see
REPEAT next to DISC on the screen.
To turn this feature off ...
See also:
Audio Communication Line Circuit
Troubleshooting
1. Turn the ignition switch to LOCK (0).
2. Disconnect climate control unit connector A (28P) and
the audio-HVAC subdisplay (with navigation) or
audio-HVAC display unit (without navigation) 12P
...
Fuel Gauge Sending Unit Test
NOTE: For the fuel gauge system circuit diagram, refer
to the Gauges Circuit Diagram (see page 22-336).
1. Check the No. 5 METER (7.5 A) fuse in the driver's
under-dash fuse/relay box before test ...
Trunk Lid Latch Replacement
Special Tools Required
KTC Trim Too! Set SOJATP2014*
*Available through the Honda Tool and
Equipment
Program; call 888-424-6857
NOTE:
- Put on gloves to protect your hands.
- Take care not t ...