Shift Solenoid Valve Removal and Installation

NOTE: -Do not hold the shift solenoid valve connector to remove and to install the shift solenoid valves. Hold the shift solenoid valve b o d y . -Do not install the shift solenoid valve A before ...

Mainshaft Bearing and Oil Seal Replacement

Special Tools Required -Adjustable Bearing Puller, 2 5 - 4 0 mm 07736-A01000B -Driver Handle, 15 x 135L 07749-0010000 -Attachment, 62 x 68 mm 07746-0010500 -Attachment, 72 x 75 mm 07746-0010600 1 ...

See also:

Steering Angle Sensor Replacement
SRS components are located In this area. Review the SRS component locations: 4-door (see page 24-21), 2-door (see page 24-23) and the precautions and procedures (see page 24-25). NOTE: Do not da ...

EVAP Canister Vent Shut Valve Replacement
1 o Disconnect the EVAP canister vent shut valve 2P connector (A). 2. Remove the cap (B). 3. Remove the EVAP canister vent shut valve (C). 4. Install the parts in the reverse order of remova ...

DTC Troubleshooting
DTC indicator 1: An Open in the Air Mix Control Motor Circuit 1. Turn the ignition switch to LOCK (0), and then to ON (II). 2. Do the self-diagnostic function with the HVAC control unit (see pa ...