Honda Accord: Throttle Body
Disassembly/Reassembly
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Fuel and Emissions / Intake Air System / Throttle Body
Disassembly/Reassembly
Throttle Body Removal/Installation
Do not insert your fingers into the installed throttle body when you turn
the ignition switch to ON (II) or while the
ignition switch is in ON (II). If you do, you will seriously injure your finger ...
See also:
Rear Bumper Finisher Cover
Replacement
2-door
NOTE:
- Put on gloves to prevent damage.
- Take care not to scratch the rear bumper or the body.
- When prying with a flat-tip screwdriver, wrap it with
protective tape to prevent dama ...
ELD Replacement
1. Do the battery terminal disconnection procedure (see
page 22-91).
2. Remove the upper cover (A), then remove the two
positive ( + ) terminals (B).
3. Remove the under-hood fuse/relay box (C ...
Mainshaft Bearing and Oil Seal Replacement
Special Tools Required
- Oil Seal Driver, 65 07JAD-PL90100
- Adjustable Bearing Puller, 20-”40 mm 07736-A01000B
- Bearing Driver Attachment, 42 x 47 07746-0010300
- Driver Handle, 15 x 135L ...