Honda Accord: Region Setting
The audio system’s region setting will be lost when the battery is disconnected or goes dead.
If the Region Select screen appears, you need to set the region for the audio system. Follow the steps below:
1. Press 
to select OK.
2. Rotate 
to select the region you
live in, then press 
.
3. You will receive a confirmation message on the screen. Rotate
to select Yes,
then press 
.
The region setting is required only when the battery power is temporarily disconnected. It is set to your vehicle’s region type by the factory.
You cannot change the setting once you have completed the setting procedure. Contact a dealer if you selected an incorrect region.
Audio System Theft Protection*
The audio system is disabled when it is disconnected from the power source,
such as
when the battery is disconnected or goes dead.
• Reactivating the audio system
1. Set the power mode to ON, ...
Audio Remote Controls
Allows you to operate the audio system while driving.
The CD mode appears only when a CD is loaded.
...
See also:
Automatic Transmission/CVT\
• Creeping
The engine runs at a higher idle speed and creeping increases.
Keep the brake pedal firmly depressed when stopped.
• Kickdown
Quickly depressing the accelerator pedal while drivin ...
Replacing Rear Bulbs
1. Open the trunk.
Remove the screws in the center
of each of the two fasteners on the
side of the trunk lining. Pull the
lining back.
2. Determine which of the three
bulbs is burned out: ...
Output Shaft (Countershaft) Speed
Sensor Replacement
1. Remove the nut securing the under-hood fuse/relay
box, and swing it out of the way.
2. Remove the intake air duct and the air cleaner
housing.
3. Disconnect the output shaft (countershaft) ...