Replacing a Fog Light Bulb

If equipped Your vehicle uses halogen light bulbs. When replacing a bulb, handle it by its plastic case, and protect the glass from contact with your skin or hard objects. If you touch the gl ...

Cleaning the Seat Belts

If your seat belts get dirty, use a soft brush with a mixture of mild soap and warm water to clean them. Do not use bleach, dye, or cleaning solvents. Let the belts air dry before you use ...

See also:

Washer Reservoir Replacement
1. Remove the right inner fender (see page 20-290). 2. Disconnect the 2P connector(s) (A) from the washer motor (B) and the washer fluid level switch (Canada models). Washer Reservoir Capacity: ...

Driver's Outer Middle Pad Removal/Installation
Special Tools Required KTC Trim Tool Set SOJATP2014* *Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE: - Take care not to scratch the dashboard or the related pa ...

Wheel Runout Inspection
1. Raise and support the vehicle (see page 1 -13). 2. Check for a bent or deformed wheel. 3. Set up the dial gauge as shown, and measure the axial runout by turning the wheel. Front and rear w ...