Component Location Index

...

Resetting the Moonroof Control Unit

Resetting the moonroof is required when any of the following have occurred: • The moonroof was moved manually while the battery was dead or disconnected. • The moonroof motor was replace ...

See also:

Tensioner Pulley Replacement
1. Remove the auto-tensioner (see page 4-31). 2. Clamp the auto-tensioner (A) by using two 8 mm bolts (B) and a vise (C) as shown. Do not clamp the auto-tensioner itself, then remove the tensione ...

Taillight and Back-Up Light Bulbs
When replacing, use the following bulbs. 1. Remove the holding clips using a flat-tip screwdriver, then pull the lining back. 2. Turn the socket to the left and remove it. 3. Remove the ol ...

Driveshaft Inspection
1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and the boot ban ...