Honda Accord: Front Bumper Fog Light Cover
Replacement
2-door
NOTE; Take care not to scratch the front bumper.
1. Remove the front bumper (see page 20-255).
2. Remove the screws (A, B), then remove the front bumper fog light cover (C) from the front bumper (D).
3. Install the bumper fog light cover in the reverse order of removal.
Front Bumper Removal/Installation
NOTE:
- Have an assistant help you when removing and
installing the front bumper.
- Take care not to scratch the front bumper
or the body.
- Put on gloves to protect your hands.
- When pr ...
Front Air Spoiler Replacement
NOTE:
-Take care not to scratch the front bumper,
- Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver,
wrap it with
protective tape to prevent damage.
1. Remove ...
See also:
Rear Seat Armrest Replacement
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and
Equipment
Program; call 888-424-6857
4-door
NOTE:
- Use the appropriate tool from the KTC trim tool s ...
Changing a Flat Tire
If you have a flat tire while driving,
pull over safely. Drive slowly along
the shoulder until you get to an area
far away from traffic lanes.
The vehicle can easily roll off
the jack, se ...
Trim Removal/Installation - Trunk Area
Special Tools Required
KTC Trim Tool Set SOJATP2014*
* Available through the Honda Tool and
Equipment
Program; call 888-424-6857
NOTE:
- Put on gloves to protect your hands.
- Take care not ...