Honda Accord: Emergency Engine Stop
If you cannot stop the engine by pressing the ENGINE START/STOP button, do either of the following operations:
• Press and hold the ENGINE START/STOP button for about two seconds.
• Firmly press the ENGINE START/STOP button two times.
Do not press the button while driving unless it is absolutely necessary for the engine to be switched off.
The steering wheel will not lock.
The power mode changes to VEHICLE OFF with the shift lever in (P, and to ACCESSORY with the shift lever in any position other than (P.
The power mode changes to VEHICLE OFF.
Do not press the button while driving unless it is absolutely necessary for the engine to be switched off.
If the Smart Entry Remote Batteryis Weak
If the beeper sounds, the indicator on the ENGINE START/STOP button flashes,
and the engine won’t start.
The To Start, Hold Remote Near Start Button message appears on the
multiinformation
...
Jump Starting
• Jump Starting Procedure
Turn off the power to electric devices, such as audio and lights. Turn off
the engine,
then open the hood.
1. Connect the first jumper cable to your
vehicle's bat ...
See also:
HazardWarning Button
Push the button between the center
vents to turn on the hazard warning
lights (four-way flashers). This
causes all four outside turn signals
and both turn indicators in the
instrument pane ...
Bearing Removal
Special Tools Required
•Attachment, 78x80 mm 07NAD-PX40100
-Driver Handle, 15 x 135L 07749-0010000
-Bearing Driver Attachment, 42 x 47 07746-0010300
1. Remove the idler gear shaft (see page 1 ...
Symptom Troubleshooting
SRS indicator does not come on
NOTE: 2-door: Before replacing t h e SRS u n i t , check the
SRS u n i t software v e r s i o n w i t h t h e HDS. I f t h e software
v e r s i o n is not t h e lates ...