Honda Accord: Driver's Outer Middle Pad
Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE: - Take care not to scratch the dashboard or the related parts. - Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Remove the driver's dashboard side vent (see page 20-177).
2. Gently pull out along the edge of the driver's outer middle pad (A) to release the hooks (B), then remove the pad.
3. Install the pad in the reverse order of removal, and push the hooks into place securely.
Side Defogger Vent Trim
Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014*
* Available through the Honda Tool and
Equipment
Program; call 888-424-6857
Driver's Side
NOTE:
- Take care not to scratch the dashboard or ...
Driver's Inner Middle Pad
Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014*
* Available through the Honda Tool and Equipment
Program; call 888-424-6857
NOTE:
-Take care not to scratch the dashboard or
the related
pa ...
See also:
Sound Quality Diagnosis
Special Tools Required
Diagnostic CD 07AAZ-SDBA100
Use the following tests to check sound quality.
NOTE: Before beginning the following tests, write down
the customer's bass, treble, fader and b ...
Ignition Key Switch Test
1. Remove the steering column upper and lower covers
(see page 20-181).
2. Disconnect the 6P connector (A).
3. Check for continuity between terminals No. 1 and No.
2.
• There should ...
Servo Body Disassembly, Inspection,
and Reassembly
1. Clean all parts thoroughly in solvent, and dry them with compressed air.
Blow out all passages.
2. Inspect the valve body for scoring and damage.
3. Check shift valve D for free movement. I ...